ALL-IN-ONE NANO 3in1 kentekenhouder

Naar HeinzBikes merkshop

Custom Parts voor Harley-Davidson en alle andere motormerken

Al overgrootvader Heinz leefde voor het motorrijden en was een succesvol racer. En in zijn geest wordt het familiebedrijf tot op heden geleid: HeinzBikes Custom Parts. Aanvankelijk specialiseerde men zich op de productie van exclusieve aanbouwdelen voor Harley-Davidson motoren, trefwoord: baggerombouw. Maar inmiddels ontwikkelen en produceren HeinzBikes ook voor alle andere motormerken E-goedgekeurde LED-armaturen, LED-vork- of LED-achterknipperlichten. Bijzonder trots zijn de handwerkslieden uit het Havelland op de innovatieve All-in-One-kentekenplaathouder. Elk product van HeinzBikes wordt met liefde voor het details gemaakt en stuk voor stuk met de hand voltooid.

This product is made of high-quality aluminium and will look great on your motorbike. To ensure that it gives you years of pleasure, please observe the following instructions: To keep this product in top condition, it should be treated after long trips in winter, or in rain or salty air (near the coast), and also at periodic intervals.

Water and salt encourage corrosion. After cleaning (e.g. with Procycle Special Gel Cleaner, Order no. 10004909), we recommend regularly polishing aluminium parts with standard aluminium polish (e.g. Alu-Magic, Order no. 10004031).

Modern vehicle accessories of different types now frequently carry an "E" approval mark valid throughout Europe. This "E" mark, which is made up of a combination of letters and numbers, is clearly displayed on the product and shows the application tested, the country in which testing was carried out and, where appropriate, the vehicle type to which approval applies. EC type approval for exhaust systems, for example, are always issued for a specific vehicle type, whereas in the case of lighting, they apply to an entire group of vehicles, e.g. motorcycles.
This certification mark is the sole proof of legality stipulated by law, i.e. no written report or entry in the vehicle documents by TÜV (German Technical Inspection Association) is required. However, when it comes to installing accessories, the relevant guidelines of the Road Traffic Licensing Regulations (StvZO) must always be observed.
At at a roadside check or a TÜV vehicle inspection, the registered keeper is only required to show the "E" mark. It is then up to the official in charge whether to check the mark with the Federal Motor Transport Authority (KBA) in Flensburg (or equivalent type approval authority in other countries), which is able to decode all certification marks.

Original parts on newer vehicles that have been given an "E" mark at the factory may only be replaced with accessories that have likewise undergone E-approval. An E-certified mirror may not, for example, by replaced with a mirror that only has TÜV approval under the German vehicle licensing regulations.